What fits: storage surplus and cleanout volume
Two calculators. The first compares the shelf, rod, drawer and cabinet space you have with the space you are going to. The second turns the piles that will leave into cubic yards, so you can match them to a container or a truck.
The first calculator compares what you can store where you are with what you can store where you are going. The second measures the piles that will leave and turns them into cubic yards. Measure the space explains how to take the measurements, and Deciding what to keep uses the surplus. Both are arithmetic on your own figures.
Storage surplus
Measure shelf, rod and cabinet runs along the front, in feet. Count drawers. Enter the same four figures for the destination. If you are not moving, enter the space you want the room to have in the destination boxes.
The surplus is a total, not a quota for any one room. Kitchens and garages do not shed at the same rate, and a percentage that looks large for the house can be small for the room you are standing in. It also says nothing about what you should keep: that is decided in Deciding what to keep, against the measured space.
Cleanout volume
Stack or gather what will leave, then measure each pile's length, width and height in feet as you would load it. Three piles are enough for a first estimate: one room's discards, one room's donations, the furniture. The tool adds the piles, converts to cubic yards and lists the standard container sizes at least that large.
Container and truck sizes, as published
Each publisher below also sells the service, except where marked. A named size is a capacity; the box's outside dimensions differ by hauler, so we use the named size and never compute from dimensions. Ask the hauler for its own measure before you rely on any figure here.
| Publisher | Sizes it lists (cubic yards) | What it says about load size |
|---|---|---|
| Dumpsters.com (rental company) | 10, 12, 15, 20, 30, 40 | Sized by internal volume. A standard pickup bed holds about 2 to 3 cubic yards. |
| Republic Services (rental company) | 10, 15, 20, 30, 40 | Lists loads of a standard pickup truck per size; we do not repeat them because the publishers' counts disagree. |
| Waste Management (rental company) | 10, 20, 30, 40 | Each size is 8 feet wide. |
| City of Mesa, Arizona (a city that rents them) | 20, 30, 40 | Maximum length 22 feet, width 8 feet. |
Where the publishers disagree, as on how many pickup loads fill a 30 cubic yard container, we publish none of their counts: the pickup bed range above is a seller's convention, and a load's real volume depends on how it is stacked.
The tool measures a pile; it does not say what a room holds. We found no published per-room or per-house figure we trust, so there are no per-room defaults. Loose or awkward things hold less than their measured volume once loaded, so allow a margin of your own and ask the hauler how it measures.
Assumptions behind the numbers
- Linear feet are the length of shelf, rod or cabinet run, measured along the front. The surplus is the current figure minus the destination figure in each unit, and the percentage is the surplus divided by the current figure. This is arithmetic on your measurements; no source sets a quota.
- Drawers are counted, not measured, because drawers differ in depth. Extra spaces are counted and listed, not converted into feet, because they hold no standard amount.
- The box count appears only if you enter your own test: pack one box from a shelf, measure the shelf length it emptied, and enter it. We publish no default, because the figure depends on what is on your shelves.
- Cleanout volume is length times width times height of the pile, in feet, divided by 27 cubic feet per cubic yard (3 feet by 3 feet by 3 feet). The margin is yours.
- Container sizes are the nominal sizes the publishers in the table list, and the pickup bed range is Dumpsters.com's. These are sellers' figures, read on 2026-11-13, and a hauler's own measure decides what fits.